NotchLoading plan…
Loading plan…
Use your browser's Print (Ctrl/Cmd + P) and choose Save as PDF. This page works offline once you've opened it with a signal.
A pocket-hole waterfall table where the 45° miter isn't decorative — it wraps continuous 1x12 grain from the tabletop down the sides, so the corner has to be cut, not just assembled, correctly.
| Part | Qty | T × W × L | Material | ✓ |
|---|---|---|---|---|
| Face frame, long rails Both ends cut at 45°, ends NOT parallel, long point to long point. | 4 | 3/4" × 2 1/2" × 60" | 1x3 | ☐ |
| Face frame, short rails Both ends cut at 45°, ends NOT parallel, long point to long point. | 4 | 3/4" × 2 1/2" × 18" | 1x3 | ☐ |
| Waterfall top panels Both ends cut at a 45° bevel, ends NOT parallel, long point to long point. Cut these first — the grain match starts here. | 2 | 3/4" × 11 1/4" × 60" | 1x12 | ☐ |
| Waterfall side panels One end cut at a 45° bevel, long point measurement. Reserve the offcut from the top-panel cut as your reference so the grain wraps continuously. | 4 | 3/4" × 11 1/4" × 18" | 1x12 | ☐ |
| Bottom shelf | 2 | 3/4" × 11 1/4" × 58 1/2" | 1x12 | ☐ |
| Inside side panels | 4 | 3/4" × 11 1/4" × 14 3/4" | 1x12 | ☐ |
| Item | Qty | ✓ |
|---|---|---|
| 1x12, 8 ft Must be flat and fully acclimated — this is the waterfall panel and the shelf. No cupping or crowning. | 4 each | ☐ |
| 1x3, 8 ft The two face frames. | 4 each | ☐ |
| 1x2, 8 ft Center supports under the top and shelf. | 1 each | ☐ |
| Pocket hole screws, 1-1/4" coarse thread | 100 each | ☐ |
| Brad nails, 1-1/4" | 40 each | ☐ |
| Wood glue | 4 oz | ☐ |
| Stain, whitewash, and finishing supplies | 1 qt | ☐ |
Overall cost: $$. Lumber varies by region, species, and season, so we give a band rather than a figure.