NotchLoading plan…
Loading plan…
Use your browser's Print (Ctrl/Cmd + P) and choose Save as PDF. This page works offline once you've opened it with a signal.
A doorless wall cabinet with a hardwood face frame, edge-banded shelves, and pocket holes kept to the outside faces so it hangs flush with neighboring cabinets.
| Part | Qty | T × W × L | Material | ✓ |
|---|---|---|---|---|
| Sides Width matches your chosen rip depth. | 2 | 3/4" × 10 1/4" × 30" | 3/4" plywood | ☐ |
| Top and bottom | 2 | 3/4" × 10 1/4" × 34" | 3/4" plywood | ☐ |
| Hanging support | 1 | 3/4" × 3 1/2" × 34" | 3/4" plywood or 1x4 | ☐ |
| Back | 1 | 1/4" × 30" × 35 1/2" | 1/4" plywood | ☐ |
| Face frame top rail | 1 | 3/4" × 2 1/2" × 36" | 1x3 | ☐ |
| Face frame bottom rail | 1 | 3/4" × 1 1/2" × 36" | 1x2 | ☐ |
| Face frame stiles | 2 | 3/4" × 1 1/2" × 26" | 1x2 | ☐ |
| Fixed shelves Trim the front edge back 1/8" for edge banding. | 2 | 3/4" × 10 1/4" × 36" | 3/4" plywood | ☐ |
| Adjustable shelves Trim the front edge back 1/8" for edge banding. | 1 | 3/4" × 10 1/4" × 35 3/4" | 3/4" plywood | ☐ |
| Item | Qty | ✓ |
|---|---|---|
| 3/4" plywood, 18 linear feet, ripped to your chosen cabinet depth Shown ripped to 10-1/4" — any depth works, just keep it consistent across every cabinet in the run. | 18 ft | ☐ |
| 1/4" plywood, half sheet | 1 each | ☐ |
| Scrap plywood, for the hanging support A 1x4 works too if you don't have a suitable offcut. | 1 each | ☐ |
| 1x3 board, 3 ft (Hardwood, matching your cabinets) | 1 each | ☐ |
| 1x2 board, 8 ft (Hardwood, matching your cabinets) | 1 each | ☐ |
| Finish nails, 1-1/4" | 20 each | ☐ |
| Finish nails, 3/4" | 20 each | ☐ |
| Wood glue | 4 oz | ☐ |
| Pocket-hole screws, 1-1/4" | 30 each | ☐ |
| Shelf pins Only needed for adjustable shelves. | 8 each | ☐ |
| Edge banding | 6 ft | ☐ |
Overall cost: $$. Lumber varies by region, species, and season, so we give a band rather than a figure.