NotchLoading plan…
Loading plan…
Use your browser's Print (Ctrl/Cmd + P) and choose Save as PDF. This page works offline once you've opened it with a signal.
A wall-mounted magazine rack built entirely from a single 1x3 board, angled so covers face outward.
| Part | Qty | T × W × L | Material | ✓ |
|---|---|---|---|---|
| Bottom | 1 | 3/4" × 2 1/2" × 10" | 1x3 | ☐ |
| Back Angled to tilt magazines forward, covers facing out. | 1 | 3/4" × 2 1/2" × 12" | 1x3 | ☐ |
| Sides Angled top edge to match the back piece. | 2 | 3/4" × 2 1/2" × 9" | 1x3 | ☐ |
| Item | Qty | ✓ |
|---|---|---|
| Pine board, 1x3, 8 ft | 1 each | ☐ |
| Pocket hole screws, 1-1/4" | 12 each | ☐ |
| Wood glue | 2 oz | ☐ |
| Wood filler | 1 each | ☐ |
| Paint | 4 oz | ☐ |
| Hanging hardware or Command strips | 1 set | ☐ |
Overall cost: $. Lumber varies by region, species, and season, so we give a band rather than a figure.
Tools: Miter Saw. Materials: Pine board, 1x3, 8 ft
Cut the 1x3 board into a bottom, a back, and two angled side pieces, sized to your preferred depth and height.
Tools: Pocket Hole Jig. Materials: Pine board, 1x3, 8 ft
Drill pocket holes in the bottom and back pieces only — leave the side pieces clean since they're the visible faces.
Tools: Drill / Driver. Materials: Pine board, 1x3, 8 ft, Pocket hole screws, 1-1/4", Wood glue
Glue and pocket-screw the bottom piece to the two side pieces.
Tools: Drill / Driver. Materials: Pine board, 1x3, 8 ft, Pocket hole screws, 1-1/4", Wood glue
Glue and pocket-screw the back piece to the sides at its angle, tilting magazines forward so covers face out.
Materials: Wood filler, Paint
Fill any exposed pocket holes with wood filler, sand smooth, and paint.
Materials: Hanging hardware or Command strips
Mount to the wall with hanging hardware or strong adhesive strips.