NotchLoading plan…
Loading plan…
Use your browser's Print (Ctrl/Cmd + P) and choose Save as PDF. This page works offline once you've opened it with a signal.
A simple angled A-frame display stand built from two identical 1x3 frames, sized to hold a row of buckets or baskets at a lean.
| Part | Qty | T × W × L | Material | ✓ |
|---|---|---|---|---|
| Frame boards | 10 | 3/4" × 2 1/2" × 35" | Pine 1x3 | ☐ |
| Frame cross braces | 4 | 3/4" × 2 1/2" × 14" | Pine 1x3 | ☐ |
| Center cross support Scribed to fit after the frames are assembled, not cut to a fixed length up front. | 2 | 3/4" × 2 1/2" × 35" | Pine 1x3 | ☐ |
| Item | Qty | ✓ |
|---|---|---|
| Pine, 1x3, 8 ft | 6 each | ☐ |
| Pocket hole screws, 1-1/4", or 2" self-tapping screws | 1 box | ☐ |
| Brad nails or staples, 1-1/4" | 1 box | ☐ |
| Wood glue | 2 oz | ☐ |
| Buckets or baskets Not included in the cost estimate — pick sizes that fit your own frame spacing. | 9 each | ☐ |
Overall cost: $. Lumber varies by region, species, and season, so we give a band rather than a figure.
Tools: Miter Saw, Pocket Hole Jig, Speed Square. Materials: Pine, 1x3, 8 ft, Pocket hole screws, 1-1/4", or 2" self-tapping screws, Wood glue
Build two identical A-frames from the frame boards and cross braces. Use a scrap block cut at 45°, or a speed square, to guide placing the boards at the correct angle. Attach with 1-1/4" pocket hole screws or 2" self-tapping screws, gluing every joint.
Tools: Brad Nailer. Materials: Pine, 1x3, 8 ft, Brad nails or staples, 1-1/4", Wood glue
Attach the two frames together with 1-1/4" nails, staples, or screws and glue. Lay a scrap board over the sides, trace the actual angle where it crosses, cut to that scribed line, and attach for additional side-to-side rigidity.
Materials: Buckets or baskets
Set your buckets or baskets into the angled frames — the lean is what holds them in place with no extra hardware.