NotchLoading plan…
Loading plan…
The whole stand is just two identical 45°-angled frames joined together, which is what makes this one of the fastest builds in the catalog — get the 45° angle right once (a scrap block cut to that angle, or a speed square, both work as a guide) and every joint in both frames repeats the same cut. The two frames lean the buckets back at a display angle rather than standing them upright, which is the entire trick behind why loose buckets or baskets sit securely on it without any hardware holding them in place — gravity and the lean do the work.
The cross support, scribed to fit after the frames are joined rather than cut to a fixed measurement up front, is what keeps the stand rigid side to side. Scribing it in place (tracing the actual angle off the assembled frame) is more reliable than trusting a calculated angle, since small variations in how square each frame came out will change that angle slightly.
| Item | Qty |
|---|---|
| Pine, 1x3, 8 ft | 6 each |
| Pocket hole screws, 1-1/4", or 2" self-tapping screws | 1 box |
| Brad nails or staples, 1-1/4" | 1 box |
| Wood glue | 2 oz |
| Buckets or basketsNot included in the cost estimate — pick sizes that fit your own frame spacing. | 9 each |
Overall cost: $. Lumber prices vary by region, species, and season, so we give a band rather than a figure we would only be pretending to know.
| Part | Qty | T × W × L |
|---|---|---|
| Frame boardsPine 1x3 | 10 | 3/4" × 2 1/2" × 35" |
| Frame cross bracesPine 1x3 | 4 | 3/4" × 2 1/2" × 14" |
| Center cross supportPine 1x3Scribed to fit after the frames are assembled, not cut to a fixed length up front. | 2 | 3/4" × 2 1/2" × 35" |
Buy 6 boards at 8 ft.
6 boards
Assumes 8 ft stock, a 1/8" saw kerf, and buying each part at its own width. Change the board size or kerf on the full board plan →
Build two identical A-frames from the frame boards and cross braces. Use a scrap block cut at 45°, or a speed square, to guide placing the boards at the correct angle. Attach with 1-1/4" pocket hole screws or 2" self-tapping screws, gluing every joint.
Attach the two frames together with 1-1/4" nails, staples, or screws and glue. Lay a scrap board over the sides, trace the actual angle where it crosses, cut to that scribed line, and attach for additional side-to-side rigidity.
Set your buckets or baskets into the angled frames — the lean is what holds them in place with no extra hardware.
No reviews yet
Sign in to review this plan or share your build.
No reviews yet. Be the first to build this.