Use your browser's Print (Ctrl/Cmd + P) and choose Save as PDF. This page works offline once you've opened it with a signal.

Coat Rack from Scraps

A wall-mounted coat rack with hand-shaped wooden hooks, built entirely from offcut scraps rather than a purchased cut list.

Cut list

Part	Qty	T × W × L	Material	✓
Hook blanks Adjust size and quantity to your own scraps — no set rule. Bottom cut at 45°; hook face cut at 65° starting 1/4" from the top corner.	6	3/4" × 1 1/2" × 4"	Scrap wood	☐
Backer boards Match each backer's width to its hook so the two read as one shape. Length and layout are entirely up to your own scrap sizes.	6	3/4" × 1 1/2" × 6"	Scrap wood	☐

Item	Qty	✓
Scrap wood, assorted sizes and species The whole point of this project — no fixed shopping list, use what you already have on hand.	1 each	☐
Finish nails or wood screws, assorted	1 box	☐
Wall-mounting screws and anchors	1 set	☐
Finish	1 can	☐

Overall cost: $. Lumber varies by region, species, and season, so we give a band rather than a figure.

1. Cut the hook blanks
Tools: Jigsaw, Tape Measure. Materials: Scrap wood, assorted sizes and species
Start each hook from a rectangular scrap roughly 3/4" x 1-1/2" x 4" long. Cut the bottom of each blank at a 45° angle.
2. Shape the hook face
Tools: Jigsaw, Pencil
Measure 1/4" in from the top corner of each blank and draw a line at a 65° angle from that mark. Cut along the marked line with a jigsaw to form the hook's catching lip.
3. Match the backer pieces
Materials: Scrap wood, assorted sizes and species
Choose a backer piece for each hook that matches the hook's width, so the hook and backer read as one continuous shape once joined.
4. Lay out the pattern
Lay your scraps alongside each other and rearrange sizes and patterns until you're happy with the overall look before fastening anything permanently.
5. Join the hooks and backers
Tools: Drill / Driver, Hammer. Materials: Finish nails or wood screws, assorted
Join each hook to its backer with nails or screws, driving fasteners carefully to avoid splitting thin scrap stock, and keeping fastener locations on opposite sides from overlapping each other.
6. Finish and mount
Tools: Drill / Driver, Random Orbit Sander. Materials: Wall-mounting screws and anchors, Finish
Sand every surface, apply your finish of choice, and mount the assembled rack to the wall with screws and anchors sized to what you're hanging on it.