NotchLoading plan…
Loading plan…
Use your browser's Print (Ctrl/Cmd + P) and choose Save as PDF. This page works offline once you've opened it with a signal.
A 12"-deep, 36"-wide double-door wall cabinet built from ripped plywood, with a wall-anchored back support, adjustable shelves, and a full-overlay face frame.
| Part | Qty | T × W × L | Material | ✓ |
|---|---|---|---|---|
| Sides | 2 | 3/4" × 10 1/4" × 30" | Plywood, 3/4" | ☐ |
| Top and bottom | 2 | 3/4" × 10 1/4" × 34" | Plywood, 3/4" | ☐ |
| Back top support | 1 | 3/4" × 3 1/2" × 34" | Plywood scrap or 1x4 | ☐ |
| Back | 1 | 1/4" × 25 1/2" × 30" | Plywood, 1/4" | ☐ |
| Face frame stiles | 2 | 3/4" × 1 1/2" × 30" | Pine 1x2 | ☐ |
| Face frame rails | 2 | 3/4" × 1 1/2" × 33" | Pine 1x2 | ☐ |
| Face frame mid stile | 1 | 3/4" × 2 1/2" × 27" | Pine 1x3 | ☐ |
| Shelves Cut to fit exactly, allowing for edge banding if used. | 2 | 3/4" × 10" × 33 3/4" | Plywood, 3/4" | ☐ |
| Item | Qty | ✓ |
|---|---|---|
| Plywood, 3/4", ripped to 10-1/4" strips, 4x8 sheet | 1 each | ☐ |
| Plywood, 1/4", for back | 1 each | ☐ |
| Pine, 1x2, 12 ft total | 2 each | ☐ |
| Pine, 1x3, 27 in | 1 each | ☐ |
| Plywood scrap or 1x4, for back support | 1 each | ☐ |
| Pocket hole screws, 1-1/4" | 1 box | ☐ |
| Finish nails, 3/4" | 1 box | ☐ |
| Edge banding, matching veneer | 1 roll | ☐ |
| Shelf pins | 4 each | ☐ |
| Full-overlay doors, 17-1/2" x 29" | 2 each | ☐ |
| Concealed hinges, 1-1/4" overlay, set | 2 set | ☐ |
Overall cost: $$. Lumber varies by region, species, and season, so we give a band rather than a figure.