Vanity Table with Shelf Hutch

Drill three pocket holes on one end of each leg board. Attach to the underside of the tabletop with 1-1/4" pocket hole screws, leaving a 1/2" overhang on each end.

Measure the distance between the two legs at the tabletop. Cut the aprons to this measurement, drill pocket holes on each end and along one edge, and attach with 1-1/4" pocket hole screws.

Build the two hutch shelf sections with brad nails and glue.

Attach the hutch top to the two shelf sections with brad nails and glue.

Attach the assembled hutch to the base with screws.

Sand all surfaces and apply primer and paint, or stain and poly.