Rustic Scrap Wood and Pipe Toilet Paper Holder

Gather up your supplies :) Don't forget the 2 washers that aren't pictured.

Using a 3/4" Spade Bit, drill a hole in your scrap piece of wood centered 2" from one end. I like to drill the hole about 3/4 of the way through, then flip the wood and finish on the other side for a cleaner hole :)

Go ahead and sand and stain your wood, and set aside.

Now, take one of your washers and place on the bottom thread of one of the small nipples.

Then screw that into one end of your tee.

Now add another nipple on the side of your tee along with the floor flange.

Then add your final short nipple, along with your elbow, 6" nipple, and an end cap.

Now, slide your 1x4 onto the top nipple over the washer. Add the other washer over the wood, and finish with the second end cap.

Use 2 pipe wrenches to tighten everything up, making sure the bottom long nipple and shelf are facing the direction you'd like :)

All finished! Now, go ahead and install. It's best if you can screw at least 2 of the holes of the floor flange into a stud in the wall. Thanks for checking out this project! Hope yours turns out great!