NotchLoading plan…
Loading plan…
Use your browser's Print (Ctrl/Cmd + P) and choose Save as PDF. This page works offline once you've opened it with a signal.
A plywood box on splayed 10° legs, two drawers on euro slides over an open shelf — a clean mid-century profile with no visible plywood edges.
| Part | Qty | T × W × L | Material | ✓ |
|---|---|---|---|---|
| Legs Both ends cut at 10° off square, ends parallel to each other. | 4 | 3/4" × 1 1/2" × 4" | 1x2 | ☐ |
| Base side rails Both ends cut at 10° off square, ends NOT parallel to each other. | 2 | 3/4" × 1 1/2" × 15" | 1x2 | ☐ |
| Base front/back rails | 2 | 3/4" × 1 1/2" × 13 3/4" | 1x2 | ☐ |
| Box top/bottom | 2 | 3/4" × 15 3/4" × 21" | 3/4" plywood | ☐ |
| Box side | 1 | 3/4" × 15 3/4" × 19 1/2" | 3/4" plywood | ☐ |
| Center shelf/divider | 2 | 3/4" × 15 3/4" × 18" | 3/4" plywood | ☐ |
| Box front/back aprons | 2 | 3/4" × 1 1/2" × 18" | 1x2 | ☐ |
| Back panel | 1 | 1/4" × 19 1/2" × 21 3/4" | 1/4" plywood | ☐ |
| Drawer sides | 4 | 3/4" × 3 1/2" × 14 3/4" | 1x4 | ☐ |
| Drawer fronts/backs (box) | 4 | 3/4" × 3 1/2" × 15 1/2" | 1x4 | ☐ |
| Drawer bottoms | 2 | 1/4" × 14 3/4" × 17" | 1/4" plywood | ☐ |
| Drawer faces | 2 | 3/4" × 5 1/2" × 17 3/4" | 1x6 | ☐ |
| Item | Qty | ✓ |
|---|---|---|
| 3/4" plywood, half sheet (4x4) Rip into 15-3/4"-wide pieces for the box top, bottom, and shelf. | 1 each | ☐ |
| 1/4" plywood, half sheet Drawer bottoms and the cabinet back. | 1 each | ☐ |
| 1x2 board, 8 ft (Pine) The four angled legs and base rails. | 2 each | ☐ |
| 1x4 board, 6 ft (Pine) Drawer box sides, fronts, and backs. | 2 each | ☐ |
| 1x6 board, 3 ft (Pine) The two drawer faces — plan assumes a true 5-1/2" wide board. | 1 each | ☐ |
| Bottom-mount euro drawer slides, 14" | 2 pair | ☐ |
| Drawer pulls | 2 each | ☐ |
| Pocket-hole screws, 1-1/4" | 60 each | ☐ |
| Finish nails, 1-1/4" | 60 each | ☐ |
Overall cost: $$. Lumber varies by region, species, and season, so we give a band rather than a figure.