NotchLoading plan…
Loading plan…
Use your browser's Print (Ctrl/Cmd + P) and choose Save as PDF. This page works offline once you've opened it with a signal.
A plywood-and-1x2-trim nightstand with a single drawer on Euro slides and an angled drawer face that doubles as a finger pull — no hardware needed.
| Part | Qty | T × W × L | Material | ✓ |
|---|---|---|---|---|
| Side panels | 2 | 3/4" × 15 1/2" × 19 1/2" | 3/4" plywood | ☐ |
| Top and shelf | 2 | 3/4" × 15 1/2" × 25 1/2" | 3/4" plywood | ☐ |
| Drawer slide spacers | 4 | 3/4" × 1 1/2" × 10" | 1x2 | ☐ |
| Top and bottom trim (rails) | 4 | 3/4" × 1 1/2" × 27" | 1x2 | ☐ |
| Vertical trim (stiles) | 4 | 3/4" × 1 1/2" × 18" | 1x2 | ☐ |
| Side trim (side rails) | 2 | 3/4" × 1 1/2" × 15 1/2" | 1x2 | ☐ |
| Inside cleats | 4 | 3/4" × 1 1/2" × 4" | 1x2 | ☐ |
| Drawer sides Match this to your actual drawer slide length. | 2 | 3/4" × 5 1/2" × 16" | 1x6 | ☐ |
| Drawer front and back Measure and cut to fit — 2-1/2" less than your drawer opening, assuming 1/2" clearance per side on your slides. | 2 | 3/4" × 5 1/2" × 21 1/2" | 1x6 | ☐ |
| Drawer bottom | 1 | 1/4" × 16" × 23" | 1/4" plywood | ☐ |
| Drawer face Rip the top edge at an angle on the table saw — this bevel becomes the finger pull. | 1 | 3/4" × 9 1/4" × 22 3/4" | 1x10 | ☐ |
| Item | Qty | ✓ |
|---|---|---|
| 3/4" plywood, ripped to 15-1/2" wide Side panels, top, and shelf. | 8 linear ft | ☐ |
| 1x2, 8 ft Edge trim throughout. | 3 each | ☐ |
| 1x6, 8 ft Drawer sides, front, and back. | 1 each | ☐ |
| 1x10, 24" Drawer face. | 1 each | ☐ |
| 1/4" plywood 16" x 23" — drawer bottom. | 1 each | ☐ |
| Brad nails, 1-1/4" and 5/8" | 60 each | ☐ |
| Euro drawer slides, 16", bottom corner mount | 1 set | ☐ |
| Wood glue and finishing supplies | 1 set | ☐ |
Overall cost: $$. Lumber varies by region, species, and season, so we give a band rather than a figure.