NotchLoading plan…
Loading plan…
Use your browser's Print (Ctrl/Cmd + P) and choose Save as PDF. This page works offline once you've opened it with a signal.
A small rolling cube with two internal cubbies, sized to tuck a desktop computer tower out of the way — doubles as a compact end table.
| Part | Qty | T × W × L | Material | ✓ |
|---|---|---|---|---|
| Cubby partitions | 3 | 3/4" × 7 1/4" × 19 1/2" | 1x8 | ☐ |
| Cubby shelves | 2 | 3/4" × 7 1/4" × 6 3/4" | 1x8 | ☐ |
| Partitions and side panel | 2 | 3/4" × 19 1/4" × 21" | 3/4" MDF or plywood | ☐ |
| Long shelf | 1 | 3/4" × 7 1/4" × 12" | 1x8 | ☐ |
| Top and bottom | 2 | 3/4" × 17" × 21" | 3/4" MDF or plywood | ☐ |
| Item | Qty | ✓ |
|---|---|---|
| 3/4" MDF or plywood, half sheet | 1 each | ☐ |
| 1x8 board, 8 ft (Pine) | 1 each | ☐ |
| Caster wheels | 4 each | ☐ |
| Wood screws, 2" (or 1-1/4" pocket-hole screws) | 30 each | ☐ |
| Wood glue | 3 oz | ☐ |
| Wood filler | 1 each | ☐ |
| Paint and finishing supplies | 1 set | ☐ |
Overall cost: $$. Lumber varies by region, species, and season, so we give a band rather than a figure.
Tools: Drill / Driver, Pocket Hole Jig. Materials: 1x8 board, 8 ft, Wood screws, 2" (or 1-1/4" pocket-hole screws), Wood glue
Screw two of the 19-1/2"-long 1x8 boards together — either 2" countersunk screws with glue, or pocket-hole screws.
Tools: Drill / Driver. Materials: 1x8 board, 8 ft, Wood screws, 2" (or 1-1/4" pocket-hole screws)
Mark the inside faces of the boards from step 1, measuring down 6" from the top and up 6" from the bottom. Position the shelves at those marks and screw in place.
Tools: Drill / Driver. Materials: 3/4" MDF or plywood, half sheet
Attach the center partition to the cubby assembly.
Tools: Drill / Driver. Materials: 3/4" MDF or plywood, half sheet
Add one of the plywood panels to the back of the assembly.
Tools: Drill / Driver. Materials: 3/4" MDF or plywood, half sheet
Attach the top and bottom panels to the shelves, keeping them flush to the shelf sides.
Tools: Drill / Driver. Materials: 3/4" MDF or plywood, half sheet, Wood screws, 2" (or 1-1/4" pocket-hole screws), Wood glue
Attach the last remaining side panel with glue and 2" screws or 1-1/4" pocket-hole screws.
Tools: Drill / Driver, Random Orbit Sander. Materials: Caster wheels, Wood filler, Paint and finishing supplies
Attach the four caster wheels to the bottom, using screws under 3/4" long so the tips don't poke through and out the inside bottom. Fill all holes with wood filler, let dry, sand, and finish as desired.