Simple Quilt Rack Console Table

If you have a hole saw close to your rod diameter — a 1-1/4" saw for a 1" dowel — use it on the center board; it's fast and clean. Otherwise, trace the rod end onto the board and cut the opening with a jigsaw. It doesn't have to be pretty; the dowel covers the edge.

Predrill and countersink the two end joints. Screw the two end boards to the top/sides first, then measure 36" to the center and predrill for the center board (the one with the cutout). Important: attach the two ends before the center so you can register the center off a square box rather than chasing it. Slide the dowel through as you set the center board so you don't box yourself out of installing it.

Prop the box on its four corner feet plus two center feet and screw them on — three screws per foot if you're using 2x2 so they can't twist, one or two is enough for chunkier stock. Check it sits level, sand, and finish.