Rolling Trash Can Cabinet

Use the cut-list to break down 3/4" plywood to the specified dimensions. Use a circlular/track saw to cut your pieces down to manageable pieces then cut to final size on the table saw.

Drill pocket holes on each end of the Cabinet Sides. Space them out every 6" or so.

Attach the Sides to the Top and Bottom pieces uses 1 1/4" pocket screws. Make sure the joints are square during assembly.

Add Two Stretchers to the Top of the cabinet along the front and back sides. Use 1 1/4" Pocket Screws to secure them in place.

• Start off by running your corner stiles through your table saw at 45 degrees.
• Once all your bevels are cut you are going to run them through your router table using a tongue and groove bit. After all your groves are cut, glue both pieces together to make a 90 degree corner.

Cut a groove in your Side Panel Rails so that it can accept a 1/4" panel. Next use your grove bit to make a tongue for face frame assembly.

• Start by installing the bottom Side Rail to your Corner Stiles with wood glue.
• Slide your Side Panels in one by one until you get to the last one. The top side panel will most likely have to be trimmed before you can install the Top Rail.

Repeat Step 7 for your Back Rails and Back Panels.

Attach your Top and Bottom Rails to the frame using 1 1/4" pocket screws. Add the Center Stile to the front frame making sure you have 16" gap on both sides.

Flip the carcass upside down and drop in the frame slowly. Once the frame is dropped in secure the carcass to the sides with a few 1 1/4" screws where the rails are.

Once your frame has been secured to the carcass flip it back over to begin making the doors.

• Start glue-ing up your door by taking one of the rails and adding wood glue to both of the tongues.
• Clamp your bottom rail to both of your stiles and begin placing center panels in until the door is complete. Drop in the top rail and let the door dry for about an hour.

Use the provided instructions from Rev-A-Shelf to attach the doors to the hardware brackets.

At this point your cabinet is ready for Hardware and Sanding/finishing. Attached cabinet pulls/knobs to each door and secure the casters to the bottom of the carcass.

Sand the frame and doors to 150 and apply your favorite stain. Once its dry add two coats of Poly and the cabinet is ready!

I made my cabinet with a granite top so i just drop it in place. If you are making a wood top, secure it to the carcass with some wood screws.