Use your browser's Print (Ctrl/Cmd + P) and choose Save as PDF. This page works offline once you've opened it with a signal.

Two-Tier Plywood Jewelry Box

A small hinged jewelry box built entirely from 1/2" plywood, with a shallow lid tray sitting on a deeper base.

Cut list

Part	Qty	T × W × L	Material	✓
Top/bottom panels	2	1/2" × 5" × 8 3/8"	1/2" plywood	☐
Bottom box front/back	2	1/2" × 3 1/2" × 9 3/8"	1/2" plywood	☐
Bottom box sides	2	1/2" × 3 1/2" × 5"	1/2" plywood	☐
Top box sides	2	1/2" × 2" × 5"	1/2" plywood	☐
Top box front/back	2	1/2" × 2" × 9 3/8"	1/2" plywood	☐

Item	Qty	✓
1/2" plywood, partial sheet One sheet yields several boxes; buy a full sheet even for one.	1 sheet	☐
Pocket hole screws, 3/4" (micro)	16 each	☐
Jewelry box hinges and latch	1 set	☐
Small mirror (optional)	1 each	☐
Wood filler	1 each	☐
Edge banding	1 roll	☐
Brad nails, 1"	1 box	☐
Paint or stain	4 oz	☐
Satin ribbon, 1/2" (optional pull-tab)	1 yard	☐

Overall cost: $$. Lumber varies by region, species, and season, so we give a band rather than a figure.