Outdoor Bar Table

Use a miter saw to cut all of the cedar 1x4 and 4x4 boards to size according to the cut list. Use an electric sander and fine-grit sandpaper to smooth all boards.

Use a Kreg Jig to drill two 3/4" pocket holes on each end of all twelve 22" cedar 1x4 boards. To make the table top, attach the 22" boards to one of the 50.25" 1x4 boards by lining up a 22" board flush with one end of the 50.25" board. Clamp to hold together flat, and attach using 1 1/4" pocket hole screws and an electric drill fitted with a Kreg screwdriver head. Continue attaching 22" boards, spaced 3/4" apart (use a scrap piece of 1x4 as a spacer). Complete the table top by repeating on the other ends of the 22" boards and the second 50.25" board.

Use a Kreg Jig to drill 3/4" pocket holes in the two 42.75" 1x4 boards and the two 21.5" 1x4 boards. Drill two holes on each end of the boards and three to four holes along one long side of each board.

• Lay the table top upside down on a soft flat surface.
• Measure and mark 1/4" in from each corner. Balance two of the 4x4 boards on two adjacent corners along one of the long sides, inset 1/4"from the front and sides according to the marks you made.
• Place one of the 42.75" boards in between the 4x4 table legs, making sure the holes along the long side of the 1x4 are facing down toward the table top.
• Attach the 1x4 to the table top and to each of the two legs using 1" pocket hole screws.

• Repeat balancing the remaining two 4x4 legs on the remaining empty corners of the table top, inset 1/4".
• Place a 21.5" 1x4 board between the legs on the short sides of the table and attach to the table top and the legs with 1" pocket hole screws as in the step above.
• Finish by placing the remaining 42.75" piece between the legs and attaching to the table top and the legs.