Skip to content
Notch
← Back to the plan

Modern Double Bathroom Vanity — board plan

What to buy, and which parts come off which board.

Buy 11 boards at 8 ft.

3" × 3"

2 boards · 9.9 board feet (includes 15% for knots and defects) · 73% of each board consumed

  1. Board 1 · 25 3/4" left over

    1. Table Legs — 34 1/2"
    2. Table Legs — 34 1/2"

  2. Board 2 · 25 3/4" left over

    1. Table Legs — 34 1/2"
    2. Table Legs — 34 1/2"

2" × 4"

2 boards · 6.2 board feet (includes 15% for knots and defects) · 52% of each board consumed

  1. Board 1 · 13 5/8" left over

    1. Back Support Rails — 32 1/2"
    2. Back Support Rails — 32 1/2"
    3. Center Supports — 16"

  2. Board 2 · 78 7/8" left over

    1. Center Supports — 16"

1" × 2"

2 boards · 2.1 board feet (includes 15% for knots and defects) · 69% of each board consumed

  1. Board 1 · 29 3/4" left over

    1. Face Rails — 32 1/2"
    2. Face Rails — 32 1/2"

  2. Board 2 · 29 3/4" left over

    1. Face Rails — 32 1/2"
    2. Face Rails — 32 1/2"

3/4" × 18 3/4"

1 board · 7.7 board feet (includes 15% for knots and defects) · 73% of each board consumed

  1. Board 1 · 25 3/4" left over

    1. Cabinet Shelves — 34 1/2"
    2. Cabinet Shelves — 34 1/2"

3/4" × 16"

2 boards · 16.8 board feet (includes 15% for knots and defects) · 93% of each board consumed

  1. Board 1 · 6 5/8" left over

    1. Plywood Panels — 29 1/2"
    2. Plywood Panels — 29 1/2"
    3. Cabinet Doors — 29"

  2. Board 2 · 7 5/8" left over

    1. Cabinet Doors — 29"
    2. Cabinet Doors — 29"
    3. Cabinet Doors — 29"

3/4" × 3/4"

2 boards · 0.4 board feet (includes 15% for knots and defects) · 52% of each board consumed

  1. Board 1 · 13 5/8" left over

    1. Shelf Supports — 32 1/2"
    2. Shelf Supports — 32 1/2"
    3. Shelf Supports — 16"

  2. Board 2 · 78 7/8" left over

    1. Shelf Supports — 16"

Cuts are listed longest-first, which is how they should be made: the awkward pieces get placed while there is still board to place them on. The layout assumes one end of each board is squared off (1") and that every cut costs 1/8" of kerf — the reason six 16″ parts do not fit on a 96″ board.