Kids Clubhouse & Loft Bed

Using 2 1/2" Pocket hole screws attach the 2x4 posts to the side rails as shown. Attach the 2x2's spaced equally using 2 1/2" pocket hole screws to the top guard rail and the mattress support.

Assemble the front frame using the same methods as the front except without the bottom rail.

Assemble the two side frames like using the same methods as the back frame.

Use clamps to hold your frames together while you drill your holes for your bolts. There should be one bolt at the top of each post as well as one bolt half way down.

Using 2 1/2" Kreg screws attach the door frame 2x4 to the front bed frame from the right end.

Using 2 1/2" Kreg screws screw the 2x2 window frame 12" from the door opening and a second one 39" from the left bed post. Screw the top 2x2 window frame 5 1/2" from the top 2x4" and one 11" from the bottom 2x4" using 1 1/2" Kreg screws.

Glue and screw the 2x2" mattress rails to the bottom of the 2x4" frames. using 3" wood screws.

Space the 18 bed slats out evenly and nail in place with brad nails.

Cut 4 - 2"x2" to 28 3/4" long. One end should be cut at 50 degrees and the opposite end cut to 40 degrees. The roof frame should be 18" tall. Using glue and brad nails, nail the corners of the roof frame and use 3" wood screws to screw the frame down onto the bed posts from the corners.

Using 2" Kreg Screws attach the two 2x2 boards at the top of the roof frame and one 6" from the bottom of the rood frame. The Kreg clamp comes in very handy for this part, especially if you don't have a second set of hands to hold the 2x2's in place.

Using a nail gun attach the 1x6" siding pieces with a 3/4" gap on all four sides. UPDATE Make sure to install three siding pieces to the back frame as a guard rail along with three siding pieces to the foot of the bed so that the railing is sitting at least 5" above the top of the mattress.

Nail the roof slats into place with 3/4" spacing and a 1" hang off on the two ends. I found that it was much easier to paint the slats before putting them in place.

Attach the 2x2x27" with 2" Kreg screws to the window frame. Attach the 2x2x8" with 2" Kreg screws to the horizontal pane and to the window frame.

Use 3 - 3" screws on each side of the steps of the ladder to the two ladder posts.

Sand the bed and paint or stain your however you choose. Finish up with a very fine grit sand paper for create a smooth finish.

Using the flush mount hangers attach the ladder to the center of the door opening with the screws provided.

Visit me at TheTaleofanUglyHouse.com