Use your browser's Print (Ctrl/Cmd + P) and choose Save as PDF. This page works offline once you've opened it with a signal.

Farmhouse Play Table

A kid-height table from four store-bought legs, a premade panel top, and four aprons. The fastest real table you'll build.

Cut list

Part	Qty	T × W × L	Material	✓
Short aprons	2	3/4" × 2 1/2" × 16 1/2"	1x3	☐
Long aprons	2	3/4" × 2 1/2" × 40 1/2"	1x3	☐

Item	Qty	✓
End-table legs Store-bought turned legs. Any 20–24" table leg suits a kid's height.	4 each	☐
1x3, 8 ft (Pine) Aprons.	1 each	☐
Premade project panel, 24" x 48" Edge-glued panel for the top.	1 each	☐
Pocket-hole screws, 1-1/4"	24 each	☐
Wood glue	3 oz	☐

Overall cost: $$. Lumber varies by region, species, and season, so we give a band rather than a figure.

Drill / Driver
Pencil
Pocket Hole Jig
Joins the aprons to the legs and the top to the base.
Random Orbit Sander
Safety Glasses
Speed Square
Tape Measure
Circular Saw — optional
Only if you need to trim the aprons; a miter saw or hand saw works too.
Hearing Protection — optional

1. Attach the short aprons
Tools: Drill / Driver, Pocket Hole Jig. Materials: End-table legs, 1x3, 8 ft, Pocket-hole screws, 1-1/4", Wood glue
Attach the two short aprons to two legs each, forming the end assemblies. Make sure the pocket holes for attaching the tabletop later face upward and sit on the inside faces, where they stay hidden. Getting this orientation right now saves a fight later.
2. Join with the long aprons
Tools: Drill / Driver, Pocket Hole Jig, Speed Square. Materials: 1x3, 8 ft, Pocket-hole screws, 1-1/4", Wood glue
Attach the two long aprons to the leg sets, tying the base into a rectangle. Check it for square before the last joint — the premade top will be flat, so any wobble will come from a racked base.
3. Attach the top
Tools: Drill / Driver, Pocket Hole Jig, Random Orbit Sander. Materials: Premade project panel, 24" x 48", Pocket-hole screws, 1-1/4"
Center the base upside down on the underside of the premade panel and screw up through the aprons' upward-facing pocket holes into the top. Sand any sharp edges — this is a kids' table — and finish with a durable, wipeable coat.