Entryway Cubby Bench and Hook Shelf Set

Attach the bottom, dividers, and sides with screws or pocket holes and glue.

Nail the top back trim to the back of the seat, then attach the seat to the base with screws or pocket holes.

Measure and cut the top side trim, footer sides, and footer front to fit, and attach with brad nails and glue.

Cut the plywood back with a circular saw, saving the scrap for the shelf back, and attach with 3/4" brad nails.

Nail the shelf boards, dividers, and sides together with glue and 1-1/4" brad nails, angling the side cuts to avoid a sharp corner at eye level.

Attach the top back and top front with 1-1/4" brad nails and glue.

Attach the shelf back with 3/4" brad nails and glue. Attach the double hooks to the hook board.

Sand and finish both pieces. Hang the shelf by locating a wall stud and screwing through the hook board into it, hiding the hole with wood filler and paint or stain.