DIY Wood Candle Holder

Instructions

1. 1. Step 1 - Trim 4x4 Board to 2 1/2"x2

   The actual size of 4x4 is 3 1/2"x3 1/2". This is too large for these types of candles. So we need to reduce the actual size to 2 ½” x 2 ½”. Take a 4x4 board, and trim 1/2 an inch on all four sides using a table saw. You could just trim 1" from two sides to get the job done quicker, but then you'll have one rounded corner and three sharp corners. So that's why I trimmed all four sides. I didn't have a full 6-foot long board but I had smaller 4x4 scrap pieces laying around from my previous projects. And it works just as good.

2. 2. Step 2 - Cut Candle Block Pieces

   Then with a miter saw, cut the 2 ½” x 2 ½” board into small blocks ranging from 2” to 6” long. I didn't provide lengths for these blocks, because these are totally random and you could cut any length that you'd like. You would need 21 of these blocks.

3. 3. Step 3 - Drill 1 1/2" Holes for Can

   • Once all 21 blocks are cut, use a ruler or a square and draw a line from one corner to the next.
   • Then draw another line from the other two corners creating an X on the top of the block. The center of the X is the exact middle where you need to drill the hole for the candle.
   • Drill a ½” deep hole using 1 ½” full thread tip drill bit.

4. 4. Step 4 - Sand the Wood Candle Block

   Now using a random orbital sander, sand any rough edges.

5. 5. Step 5 -Stain and Paint Candle Hold

   • For this step, you could stain or paint any color you want. I used Briarsmoke stain and white paint.
   • First, apply a coat of pre-stain, then Briarsmoke stain and wipe it off with a shop paper towel.
   • Then lightly brush white paint over the stain to make a whitewash effect. You could arrange these wood candle blocks any way you'd like. You're done with the DIY Wood Candle Holder!