Bike Wall Hanger Dropzone

Cut notches out of the back piece with a jigsaw so the ends of the 1x4 sides seat into it cleanly. This locks the sides in position and takes some of the shear load off the screws.

Screw the two 1x4 sides to the back with two screws into each. This is the structural joint that carries the bike, so use ample glue, and take the extra minute to predrill if the wood shows any sign of splitting. A split here means the bike ends up on the floor.

Attach the bottom shelf to the sides and back with glue and screws, predrilling if needed. Then add the front board — it's not structural, so 1-1/4" brad nails are fine here if you have them, or a couple of screws.

Use a jigsaw or hole saw to cut the saddle notch that cradles the bike's top tube. It doesn't need to be deep — just enough to keep the bike from rolling sideways off the shelf. Sand everything smooth.

Mount the hanger to the wall with the 3" screws driven into a wall stud, at least two of them. Drywall anchors are not enough for a bike that hangs here full-time. Add the handle and hooks underneath for helmet and keys.