Angled Tabletop Plant Stand

Start by making all cuts according to the cut list. Then, make 30 degree miter cuts to the following: - Trunk- parallel cuts to make each side 14" - Low Branch- opposing cuts to make long edge 8" - High Branch- opposing cuts to make long edge 10" - Stump- parallel cuts to make each side 2"

Attach the Low Branch to the Trunk 2" from the end using pocket holes.

Attach the High Branch to the Trunk 3 1/2" up from the Low Branch using pocket holes.

Attach the Trunk with branches to the Base 3/4" from the edge and centered using pocket holes.

Attach the Stump to the Base on the other side, 2" in from the edge using pocket holes.

• Attach the four Platforms to the tops of the branches, trunk and stump.
• Spread wood glue on the top of the angled piece and place the Platforms centered. Secure with nails or let dry naturally.

Stain and seal according to your decor style. Add small potted plants to finalize the "tree" look on your angled plant stand!

Check out www.CharlestonCrafted.com for more behind the scenes photos and more projects like this one!