NotchLoading plan…
Loading plan…
Use your browser's Print (Ctrl/Cmd + P) and choose Save as PDF. This page works offline once you've opened it with a signal.
A pair of angled sawhorse bases with threaded-rod legs that raise and lower — the same table works as a standing desk or drops to coffee-table height.
| Part | Qty | T × W × L | Material | ✓ |
|---|---|---|---|---|
| Legs Both ends 15° off square, ends ARE parallel (short point to long point). | 8 | 1 1/2" × 3 1/2" × 16 5/8" | 2x4 | ☐ |
| Top and bottom caps | 4 | 1 1/2" × 5 1/2" × 23 1/2" | 2x6 | ☐ |
| Lower leg spacers Both ends 15°, ends NOT parallel (long point to long point). | 4 | 1 1/2" × 3 1/2" × 5 3/8" | 2x4 | ☐ |
| Upper leg spacers Both ends 15°, ends NOT parallel (long point to long point). | 4 | 1 1/2" × 3 1/2" × 8 7/8" | 2x4 | ☐ |
| Lower shelf slats | 4 | 3/4" × 3 1/2" × 23 1/2" | 1x4 | ☐ |
| Item | Qty | ✓ |
|---|---|---|
| 2x4 board, 8 ft (Pine or Fir) | 2 each | ☐ |
| 2x6 board, 6 ft (Pine or Fir) | 1 each | ☐ |
| 1x4 board, 8 ft (Pine) | 1 each | ☐ |
| Tabletop, minimum 24" x 48" Anything flat and sturdy — the source laminated two layers of plywood. | 1 each | ☐ |
| 5/8" all-thread rod, 18" The adjustable legs. A different diameter works if the fittings match. | 4 each | ☐ |
| Floor flanges to match all-thread Thread the rod into these; fasten with screws no longer than 1-1/2". | 4 each | ☐ |
| Nuts to match all-thread | 8 each | ☐ |
| Washers to match all-thread | 8 each | ☐ |
| Wood screws, 2" and pocket screws 2-1/2" | 30 each | ☐ |
| Wood glue | 4 oz | ☐ |
Overall cost: $$. Lumber varies by region, species, and season, so we give a band rather than a figure.