NotchLoading plan…
Loading plan…
Use your browser's Print (Ctrl/Cmd + P) and choose Save as PDF. This page works offline once you've opened it with a signal.
A wide rolling console with a row of open vertical cubbies, built from 1x12 boards and trimmed in 1x2.
| Part | Qty | T × W × L | Material | ✓ |
|---|---|---|---|---|
| Sides | 2 | 3/4" × 11 1/4" × 30 1/4" | Pine 1x12 | ☐ |
| Top | 1 | 3/4" × 11 1/4" × 63 1/2" | Pine 1x12 | ☐ |
| Shelves | 2 | 3/4" × 11 1/4" × 62" | Pine 1x12 | ☐ |
| Vertical dividers | 6 | 3/4" × 11 1/4" × 14" | Pine 1x12 | ☐ |
| Top and bottom trim | 4 | 3/4" × 1 1/2" × 63 1/2" | Pine 1x2 | ☐ |
| Vertical trim Recommend cutting to your project's actual measurements. | 10 | 3/4" × 1 1/2" × 28" | Pine 1x2 | ☐ |
| Shelf trim | 8 | 3/4" × 1 1/2" × 14" | Pine 1x2 | ☐ |
| Caster wheel supports | 3 | 3/4" × 1 1/2" × 11 1/2" | Pine 1x2 | ☐ |
| Item | Qty | ✓ |
|---|---|---|
| Pine, 1x12, 8 ft | 4 each | ☐ |
| Pine, 1x2, 8 ft | 8 each | ☐ |
| Finish nails, 2" | 1 box | ☐ |
| Finish nails, 1-1/4" | 1 box | ☐ |
| Wood glue | 4 oz | ☐ |
| Caster wheels | 3 each | ☐ |
| Sandpaper, assorted grit | 3 sheet | ☐ |
Overall cost: $$. Lumber varies by region, species, and season, so we give a band rather than a figure.
Tools: Hammer. Materials: Pine, 1x12, 8 ft, Wood glue
Fasten through the sides with 2" nails and glue into the shelves. Then fasten the top in place.
Tools: Hammer. Materials: Pine, 1x12, 8 ft, Wood glue
Mark the proper spacing for all six dividers before fastening any of them. Fasten the bottom dividers in place, fastening through the shelves into the ends of the dividers. Fasten through the top into the top ends of the dividers. To secure the bottom edge of the top divider, toenail at an angle through the bottom corner into the shelf. Use 2" nails and glue throughout.
Tools: Hammer. Materials: Pine, 1x2, 8 ft, Wood glue
Fasten the trim in place with 2" nails and glue, measuring to fit your actual project rather than the plan's numbers — mark the top and bottom trim positions before fastening the vertical trim. The shelf trim sits flush with the top of each shelf.
Tools: Drill / Driver, Hammer, Random Orbit Sander. Materials: Pine, 1x2, 8 ft, Caster wheels, Sandpaper, assorted grit
Fasten the caster supports to the bottom of the piece with 1-1/4" nails and glue, then attach the casters to these supports.
Sand every surface and finish.