Square Farmhouse Pedestal Table

Sandwich the three 2x4s face to face: glue and 2-1/2" screws join the first two; the third goes on with glue and 2" brads (its faces show, so no screw heads). Clamp or weight the stack flat while it cures — a twisted core makes a leaning table, permanently.

Mark the bottom foot board's position and attach the core to it from underneath, glue and screws, dead square to the post. Add the second-layer 30°-bevel board on top of it (dry-set the step-4 arm boards as placement guides — the source's tip), then fill in the beveled arm pieces in both layers and the 1x4 blocking.

The stepped 45°/30° bevels are rough stairs right now; sanding turns them into the swept curve. That's the next-to-last step, not this one.

Repeat the layered construction at the top of the post — the spider that will carry the tabletop. Mark, attach the main board, add the cross and arm boards with 2-1/2" screws and glue, outside edges flush per the source.

Face the pedestal's remaining sides with the 1x4 trim (glue and brads). Draw one arch template on cardboard, trace it onto the eight 2x8 corbel blanks, jigsaw them out, and attach with screws and glue at the post-to-foot and post-to-spider transitions.

Eight matching corbels from one template beats eight freehand interpretations — this is the detail people touch.

Now the sculpture step: sand the stepped bevel joints on the feet until each reads as one continuous curve. A coarse grit does the shaping; finish through the grits.

Install floor levelers under the four foot ends with cork pads. A pedestal table WILL rock on a real floor without them — one contact patch, no forgiveness.

Edge-join the seven 2x6 planks with 1-1/2" pocket holes and 2-1/2" pocket screws on a flat, level surface, clamping each seam flush. Frame the underside with the 2x4s — CUT TO FIT against your actual panel — and add the decorative 1x2 and 2x2 underside trim if you're keeping the full look (both are omittable, per the source).

Center the base upside down on the inverted top and screw the spider to the tabletop frame. LEAVE THE GLUE OFF, per the source — this table is heavy, and screws-only means it splits into two carryable halves at every future move.

Finish, flip, and claim the breakfast nook. No table leg will ever argue with a chair here again.