Flip-Top Storage Bench with Cubbies

Cut all the plywood pieces from the sheet according to the cut list. Getting the sheet cut into two smaller pieces at the store first makes the individual cuts more manageable if you're working without a table saw or track saw.

Assemble each side panel with its 2x2 leg blocking using glue and 2" nails.

Add the 1x3 trim to the top and bottom of each side panel, secured with glue and 1-1/4" finish nails.

Once both sides are complete, attach the back panel with glue and 2" nails, keeping the top edges flush. Check the assembly for square now, while it's still easy to correct — a racked box will bind against the lid later.

Install the bottom shelf panel, then the center divider that splits the lower cubby in two.

Add the front panel. Don't forget to nail up through the underside of the shelf into the front panel, not just through the front into the sides.

Cut and attach the 1x3 lid edge trim, measuring to fit rather than trusting the cut list exactly.

Cut the lid panel with enough overhang beyond the box opening on all sides to actually get a grip when lifting it — about 1/4" to 1/2" is enough. Attach the lid to the back edge with your chosen hinge hardware.